Viewing The Connections - Side Connectors; Power Connection; Aerial Connection - Luxor LX329152 LED Operating Instructions Manual

6. SPDIF Coaxial Out
Use an SPDIF coaxial cable to trasfer audio signals to a device that has SPDIF input.

Viewing the Connections - Side Connectors

1. CI Slot is used for inserting a CI card. A CI card allows you to view all the channels that
you subscribe to. For more information, see "Conditional Access" section.
2. USB Inputs.
Note that programme recording feature is available via these USB inputs. You can
connect external hard disk drives to this input.
3. Component Video Input (YPbPr)
You can connect the component video and audio sockets with a device that has
component output. To do this, you must use the supplied component video connection
cable for enabling connection. First, plug single jack of the cable to the TV's YPbPr
socket (side). Afterwards, insert your component cable's (not supplied) connectors into
the plural part of the Component video connection cable. Colours of the connected
jacks should match.
4. Side audio-video connection
of external devices. To make a video connection, you must use the supplied AV
connection cable for enabling connection. First, plug singular jack of the cable to the
TV's Side AV socket. Afterwards, insert your video cable's (not supplied) connector into
the YELLOW input (located on the plural side) of the supplied AV connection cable.
Colours of the connected jacks should match.
To enable audio connection, you must use RED and WHITE inputs of the side AV
connection cable. Afterwards, insert your device's audio cable's connectors into
the RED and WHITE jack of the supplied side AV connection cable. Colours of the
connected jacks should match.
Note: You should use audio inputs of side AV connection cable (RED & WHITE) to enable sound
connection when connecting a device to your TV by using PC or COMPONENT VIDEO input.
5. Headphone jack is used for connecting an external headphone to the system. Connect to the
HEADPHONE jack to listen to the TV from headphones (optional).

Power Connection

IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.

Aerial Connection

• Connect the aerial ,cable TV plug to the AERIAL INPUT socket located at the rear of the TV.
03_MB60_[GB]_ypbpr_1910UK_PVR_IDTV_TC_NICKEL16_32915WLED_10073970_50192683.indd 77 03_MB60_[GB]_ypbpr_1910UK_PVR_IDTV_TC_NICKEL16_32915WLED_10073970_50192683.indd 77
outputs digital audio signals of the currently watched source.
is used for connecting component video.
input is used for connecting video and audio signals
English - 77 -
06.06.2011 13:52:27 06.06.2011 13:52:27