Joyner TROOPER-T2 Owner's Manual page 80

4.4. Rotate camshaft a round, keep the
position as the right figure, measure
the clearance again.
First Second
cylinder cylinder
IN EX IN
— — —
If exceed the standard of valve clearance,
replace a adjusting washer to get a proper
clearance
Attention: record the position where valve
clearance exceed the standard
and the result
4.4.1. Rotate camshaft
cam-top (valve clearance exceed
the standard) upwards, and gap of
valve lifter towards inside.
4.4.2. Rotate camshaft and the cam press
valve lifter down.
4.4.3. Load the special tool at the top of
the valve lifter around the valve lifter,
and then rotate camshaft to make
the cam-top upwards, press valve
lifter down with a special tool, and
hold it.
4.4.3.1. Move the adjusting washer out
with a screwdriver, and then
remove the washer with a magnet
iron wire from inside.
Third Fourth
cylinder cylinder
EX IN EX IN
O O — O
to make
EX
O
the
80