Table of Contents
Advertisement
User instructions
8.6.- Data transfer (Receiver download)
This RSD receiver disposes of the possibility of transfering data and
software to another RSD receiver via an RS-232 cable.
Connect the TV to the main RSD receiver and select "Data Transfer" in
the main menu.
Connect the secondary RSD receiver (it should be in STANDBY mode)
to the main RSD receiver via an RS-232 cable when the following
message appears on screen: "Please Connect Both Receivers. Using
RS-232 Communication Cable. Select OK to Continue".
Next select the "OK" box and press the OK button.
In the "Data Transfer" menu mark the options that you need:
- User Data transfer: Transfers the satellite, transponder and channel
data.
- Software transfer: Transfers the RSD software.
Begin the data transfer by selecting "Start".
During the transfer, the following messages will appear onscreen:
- Connecting...: This means that the receivers are being connected via
the RS-232 cable.
- Connection completed: The connection has been carried out
succesfully.
- Loading .. blocks: Displays the number of blocks that have been
loaded.
- Writing data: Writing the software into the memory of the secondary
receiver.
- Data transfer completed: The data transfer has finished.
If you want to cancel the transfer, either of data or of software, select the
"STOP" option and press the OK button. You will then return to the
previous menu.
Once the data transfer has finished, you should switch the secondary
receiver off and then back on again.
If you have transferred software, switch the secondary receiver back on
again and select "Factory Default".
Note:
Take care to avoid producing an interruption in the flow of electricity during the transfer of data, because the Receiver would
lose the data.
52
"RSD - 7235"
Please Connect Both Receivers
Using RS-232 Communication Cable.
Select OK to Continue.
OK
Cancelar
User Data Transfer
Software Transfer
Start
User Data Transfer
Conecting ...
0%
Stop
Advertisement
Table of Contents
