Televes RSD-7235 User Instructions page 20

User instructions
The receiver also disposes of the manual "Set PID" option, although it
should know this data.
In general, this option does not need to be used as the receiver
automatically detects all the programmes contained in the transponder.
However, for some programmes that are transmitted in test mode, we
don't dispose of the appropriate information.
In cases such as these, you can manually enter the PID's of the desired
programme, so that this is recognised by the Receiver.
Each PID can be entered as a decimal value.
To confirm the data that has been entered, select the "OK" box and then
press the OK button.
The option "Delete TP" lets you erase the transponder data that is
selected in the menu.
When this option is selected, a message will appear asking us to confirm
if we want to erase the transponder (YES) or if we want to cancel the
command (NO).
Note:
When the message "Unlocked" appears in the signal level, you must check the following points:
- Adjust the antenna's position until the level changes to "Locked"
- Modify the transponder values.
49
"RSD - 7235"
Antenna 1
Transponder TP52
Frequency 12168
Symbol Rate 27500
Polarization Ver
Set PID
FEC AUTO
22KHz ON
Video PID 0
Audio PID 0
Satellite ASTRA
PCR PID 0
Univ. LNB YES
LNB Freq. 1 9750
OK Cancel
LNB Freq. 2 10600
Check Signal
14/18 Volt None
Start
22KHz None
Set PID
DiSEqC Port A
Delete TP