Video Settings - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Video settings

Video AllowWebSnapshots
Note: This setting is only available in TC7.3.0 to TC7.3.2.
Allow or disallow snapshots being taken of the local input sources, remote sites and
presentation channel. If snapshots are allowed, the snapshots may be captured both when idle
and in a call.
When snapshots are taken from a remote device, e.g. the web interface, a notification appears
on the video system's screens to alert the users that remote monitoring is in operation.
Requires user role: ADMIN
Value space: <Off/On/LocalDeviceOnly>
Off: It is not possible to capture snapshots.
On: Snapshots can be captured and displayed anywhere, e.g. on the web interface.
LocalDeviceOnly: Snapshots can only be captured and displayed on devices running the
experimental Cisco Proximity feature. The devices must be in the same room as the video
system. It will not be possible to take and see snapshots on the web interface or by using
3rd party integrations.
Video AllowWebSnapshots: LocalDeviceOnly
Example:
Video CamCtrlPip CallSetup Mode
This setting is used to switch on self-view for a short while when setting up a call. The Video
CamCtrlPip CallSetup Duration setting determines for how long it remains on. This applies when
self-view in general is switched off.
Requires user role: ADMIN
Value space: <Off/On>
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.
Video CamCtrlPip CallSetup Mode: On
Example:
D15106.04 SX10 Quick Set Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings
Video CamCtrlPip CallSetup Duration
This setting only has an effect when the Video CamCtrlPip CallSetup Mode setting is switched
On. In this case, the number of seconds set here determines for how long self-view is shown
before it is automatically switched off.
Requires user role: ADMIN
Value space: <1..60>
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
Video CamCtrlPip CallSetup Duration: 10
Example:
Video Input Connector [1..3] Name
Enter a name for the video input connector.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Video Input Connector 1 Name: ""
Example:
Video Input Connector [1..3] InputSourceType
Select which type of input source is connected to the video input.
Note that Connector 1 is the system's integrated camera.
Requires user role: ADMIN
Value space: Connector 1: <camera> Other connectors: <other/camera/PC/DVD/document_
camera/whiteboard>
other: Use this when none of the below options match.
camera: Use this when a camera is connected to the video input.
PC: Use this when a computer is connected to the video input.
DVD: Use this when a DVD player is connected to the video input.
document_camera: Use this when a document camera is connected to the video input.
whiteboard: Use this when a whiteboard camera is connected to the video input.
Video Input Connector 2 InputSourceType: PC
Example:
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
98
Administrator Guide
Setting passwords Appendices