Controlling Your Camera - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Controlling your camera

For software version TC7.3.3 and later:
You can control the camera of the video system (pan, tilt,
zoom) from the Call Control page. Only available camera
controls will appear.
For software version TC7.3.0 to TC7.3.2:
You can control the camera of the video system (pan, tilt,
zoom) from the Call Control page provided that the
AllowWebSnapshots setting is switched On. Only available
camera controls will appear.
If snapshots from the camera are shown on the web
interface, a notification will be sent to the users of
the video system (shown on the main display) that an
administrator is monitoring their video.
Whether or not snapshots of input sources are shown as illustrated,
depends on the software version, configuration, and options installed
on the video system. Refer to the About snapshots and remote
monitoring sections (► TC7.3.3 or newer or
D15106.04 SX10 Quick Set Administrator Guide TC7.3, JULY 2015.
Introduction Web interface Web interface
Navigate to: Call Control
Video
► TC7.3.0 to TC7.3.2).
System settings
Control the camera
1. Click the camera icon to open
the camera control window.
2. Use the left and right arrows
to pan the camera; the up
and down arrows to tilt it; and
+ and - to zoom in and out.
For software versions
TC7.3.0 to TC7.3.2, the
cursor must be in the image
to show the controls.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
20
Administrator Guide
Setting passwords Appendices
Camera presets
If one or more presets are defined,
click Presets... to open a list of
available presets.
Click a preset's name to move the
camera(s) to the preset position.
Click OK to close the window.
You cannot use the web interface to
define a preset; you should use the
video system's Touch user interface.