Connecting The Touch 10 User Interface - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Connecting the Touch 10 user interface

In order to use Touch 10 as user interface for the SX10
video system, Touch 10 must be paired to the system via the
network (LAN). This is referred to as remote pairing.
Connecting Touch 10 to SX10 via LAN
Connect Touch 10 and SX10 to the network wall socket or
network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up procedure
begins. Follow the instructions on screen.
When the Select codec to pair with dialog appears, note the
following:
• A list of video systems signalling that they are available
for paring will show up in the dialog. Tap the name of the
system you want to pair to followed by
Note that the following must be fulfilled for a video system
to show up in the list:
• The video system and Touch 10 must be on the same
subnet.
• The video system must have been restarted within
the last 10 minutes. If your system does not appear in
the list, try restarting it.
• If your video system does not appear in the list of
available codecs, you can pair the devices manually. Click
Select codec manually..., enter the IP address or host
name of the video system, and tap
• You have to enter the video system's administrator
username and password for the paring to commence.
If Touch 10 needs software upgrade, new software will be
downloaded from the video system and installed on the unit
automatically as part of the set-up procedure. Touch 10
restarts after the upgrade.
You can verify that Touch 10 is successfully connected to the
video system by checking that the video system's address is
displayed in the top banner.
D15106.04 SX10 Quick Set Administrator Guide TC7.3, JULY 2015.
Introduction Web interface
(page 1 of 2)
Start Pairing.
Power
• 100-240 VAC
• 50/60 Hz
Start Pairing.
System settings
SWITCH
Power
injector
AP
Video system address
The Ethernet connector
is behind the lid at the
rear of Touch 10.
109
Administrator Guide
Setting passwords
Standard
Ethernet cable
2
Standard
Ethernet cable
PoE rated
Ethernet cable
If the network infrastructure provides
1
Power over Ethernet (PoE), you do
not need a PoE injector; Touch 10
should be connected directly to the
wall socket (Ethernet switch) with a
PoE rated Ethernet cable.
For safety, the PoE source must be
in the same building as Touch 10.
The PoE rated Ethernet cable can be
up to 100 m (330 ft).
2 If the network infrastructure provides
Power over Ethernet (PoE), SX10
should be powered via Ethernet.
Then you must use a PoE rated
cable.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices Appendices
Network (LAN)
Network (LAN)
1