Lancom WLC-4006 Manual page 70

Blank
If the list of IP networks or loopback addresses contains an entry

named 'INT' or 'DMZ', the associated IP address of the IP network or
the loopback address named 'INT' or 'DMZ' is used.
Script management table
Table with the name of the script file and a WLAN profile for allocating the
script to a WLAN profile.
Configuring an Access Point in the "Managed" mode is handled via WLAN
profiles. A script can be used for setting those detailed parameters in man-
aged devices that are not handled by the pre-defined parameters in a WLAN
profile. Distribution is also handled by WLAN profiles to ensure that the Access
Points with the same WLC configuration also use the same script.
As only one script file can be defined per WLAN profile, versioning is not pos-
sible here. However, when distributing a script to an Access Point, an MD5
checksum of the script file is saved. This checksum allows the WLAN Controller
to determine whether the script file has to be transmitted again in case a new
or altered script has the same file name.
Script file name
Name of the script file to be used.
Possible values:
File name in the form *.lcs
Default:
Blank
WLAN profile
Select here the WLAN profile that the script file specified here should be
used for.
Possible values:
Selection from the list of defined WLAN profiles.
Default:
Blank
Internal script storage (script management without an HTTP server)
In contrast to firmware files, scripts involve only small volumes of data. The
WLAN Controller's internal script storage allows three scripts of up to 64KB
Chapter 4: Configuring the WLAN Controller
LANCOM WLC series
69