Table of Contents
Advertisement
LANCOM WLC series
Chapter 4: Configuring the WLAN Controller
52
Default:
Blank
Inheritance
Selection of a logical WLAN network defined earlier and from which the
settings are to be inherited ('Inheritance of parameters'
Network name (SSID)
Define an unambiguous SSID (the network name) for each of the logical
wireless LAN networks. Only WLAN clients that have the same SSID can
register with this wireless LAN network.
Possible values:
Maximum 32 ASCII characters.
Default:
Blank
VLAN ID
VLAN ID for this logical WLAN network.
Possible values:
1 to 4096
Default:
0
Special values:
1: Logical wireless LAN works untagged (no VLAN tag).
2 to 4096: Logical wireless LAN uses the VLAN with the specified ID,
assuming that the management VLAN ID is not equal to 0.
Please note that to use VLAN IDs in a logical WLAN network requires
a management VLAN ID to be set ('Management VLAN ID'
→
page 55). If a VLAN ID is specified for a wireless LAN profile, the
VLAN module is automatically activated for access points managed by
it.
Self- sufficient operation
The time in minutes that a managed-mode Access Point continues to ope-
rate in its current configuration.
The configuration is provided to the Access Point by the WLAN Controller
and is optionally stored in flash memory (in an area that is not accessible
→
page 76).
Advertisement
Table of Contents
