Table of Contents
Advertisement
LANCOM WLC series
Chapter 4: Configuring the WLAN Controller
44
In the configuration section 'WLAN Controller' on the 'General' tab, acti-
vate the options for the automatic acceptance of new Access Points and
the provision of a default configuration.
Automatically accept new Access Points: Enables the WLAN Controller
to provide a certificate to all new Access Points without a valid cer-
tificate. To this end, either a configuration for the Access Point has to
be entered into the AP table, or 'Automatically provide APs with a
default configuration' has to be activated.
Automatic provision of the default configuration: This enables the
WLAN Controller to assign a default configuration to any new Access
Point, even if no explicit configuration has been stored for it.
By combining these two options, the LANCOM WLAN Controller can auto-
matically integrate any managed-mode Access Point found in the LAN
into its WLAN infrastructure. This may, for example, be a temporary meas-
ure during the rollout phase of a WLAN installation.
On the 'Profiles' tab, select the logical WLAN networks. Add a new entry
with the following values:
Advertisement
Table of Contents
