Table of Contents
Advertisement
LANCOM WLC series
Chapter 2: Installation
Each Ethernet socket has two LEDs (green and yellow).
Green
Green
Green
Yellow
Yellow
»
USB connector (USB host)
USB
¿
Reset
Reset button (see 'Reset button functions')
´
Power switch
Switch for detaching the device from the power supply.
Please note:
For a complete detachment from the power supply please unplug the power connec-
tion.
²
Power connec-
Connector for the IEC cable (LANCOM WLC-4025+, LANCOM WLC-4100) or
tion
power supply unit (LANCOM WLC-4006)
¶
Uplink connection
Uplink
Reset button functions
The reset button offers two basic functions—boot (restart) and reset (to the
factory settings)—which are called by pressing the button for different
lengths of time.
It is not always possible to install a device under lock and key. There is conse-
quently a risk that the configuration will be deleted by mistake if a co-worker
presses the reset button too long. You can define the behavior of the reset but-
ton with a setting in WEBconfig (LCOS menu tree
28
Off
On (perma-
nently)
Flickering
Off
On (perma-
nently)
Reset button
This option controls the behavior of the reset button when it is pressed:
Ignore: The button is ignored.
Boot only: With a suitable setting, the behavior of the reset button can
be controlled; the button is then ignored or a press of the button
prompts a re-start only, however long it is held down.
No networking device attached
Connection to network device operational, not data traffic
Data traffic
1000 Mbps
10/100 Mbps
Setup
Config):
Advertisement
Table of Contents
