Table of Contents
Advertisement
LANCOM WLC series
Chapter 4: Configuring the WLAN Controller
64
Antenna grouping
LANCOM access points with 802.11 support can use up to three antennas
for transmitting and receiving data. Depending on the application the use
of the antennas can be set.
Possible values:
1+2+3: When using the device in access point mode to connect wire-
less LAN clients it is generally recommended to use all three antennas
in parallel in order to achieve good network coverage.
1+3: Antenna ports 1 and 3 are used for 2 parallel data streams for
example in point to point connections with an appropriate dual slant
antenna. The third antenna port is deactivated.
1: For applications with only one antenna (for example an outdoor
application with just one antenna) the antenna is connected to port 1
and ports 2 and 3 are deactivated
Auto: Automatic antenna selection
Default:
Auto
Special values:
Auto: The ''Auto' setting means that all available antennas are used.
IP address
Static IP address for the AP if DHCP cannot be /should not be used.
Possible values:
Valid IP address
Default:
Blank
IP parameter profile
Here you specify the profile name used to reference the IP settings for the
access point. If you retain the standard setting DHCP, the setting for the
fixed IP address is ignored and the access point is forced to obtain its IP
address via DHCP.
Possible values:
Select from the list of defined IP parameter profiles, max. 31 ASCII
characters.
Default:
Advertisement
Table of Contents
