Table of Contents
Advertisement
Possible values:
1 to 10
Default:
5
Firmware sender IP address
This is where you can configure an optional sender address for use instead
of the one automatically selected for the destination address.
Possible values:
Name of a defined IP network.
'INT' for the IP address in the first network with the setting 'Intranet'.
'DMZ' for the IP address in the first network with the setting 'DMZ'.
Name of a loopback address.
Any other IP address valid on the WLAN Controller.
Default:
Blank
If the list of IP networks or loopback addresses contains an entry
named 'INT' or 'DMZ', the associated IP address of the IP network or
the loopback address named 'INT' or 'DMZ' is used.
Firmware management table
Table with device type, MAC address and firmware version for the precise con-
trol of the firmware files in use.
Entries in the firmware management table are only necessary if cer-
tain firmware versions are to be uploaded, for example in the case of
downgrades. If devices are to use the current firmware only, no entries
are required here.
Device types
Select here the type of device that the firmware version specified here is
to be used for.
Possible values:
All, or a selection from the list of available devices.
Default:
All
Chapter 4: Configuring the WLAN Controller
LANCOM WLC series
67
Advertisement
Table of Contents
