Table of Contents
Advertisement
LANCOM WLC series
Chapter 2: Installation
LANCOM WLC-
4006
2.5
Software installation
The following section describes the installation of the Windows-compatible
system software LANtools, as supplied.
2.5.1
Starting the software setup
Place the product CD into your drive. The setup program will start automati-
cally.
30
Ethernet port on the device ·, and the other end into an available net-
work connector socket in your local network.
LAN – First of all connect your LANCOM WLAN Controller to the LAN.
Plug in one end of the supplied network cable (green connectors) to the
uplink connector on the device
network connector socket in your local network, or a free socket on a
switch.
The Ethernet ports use autosensing to recognize the data rate (10/100/
1000 Mbit) and the type (node/hub) of attached network devices. It is
possible to connect devices of different speeds and types in parallel.
Further network devices – you can optionally connect further network
devices to the LAN interfaces ·.
Configuration interface – optionally, the LANCOM WLAN Controller can
be connected directly to the serial interface (RS-232, V.24) of a PC. Use
the connection cable supplied for this. Connect the LANCOM configura-
³
tion interface
to an available serial interface on the PC.
Supply power and switch on – Using the power connection ², supply
power to the device and switch it on using the switch
rear panel.
You may skip this section if you use your WLAN Controller exclusively
with computers running operating systems other than Windows.
If the setup does not start automatically, run AUTORUN.EXE in the
root directory of the LANCOM CD.
¶
and the other end into an available
´
located on the
Advertisement
Table of Contents
