iStorage datashur personal User Manual page 9

personal
The following table depicts the possible actions when the drive is in different states:
User PIN Admin PIN
NOT SET NOT SET
SET NOT SET
NOT SET SET
SET SET
The drive has to be unlocked in user mode in order to proceed with configuring an Admin PIN.
It is set by following the instructions below:
INSTRUCTIONS
Double press the KEY Button
and hold on the 2 nd press for 3 seconds
Enter the New Admin PIN
and press KEY Button
Re - Enter the New Admin PIN
and press KEY Button
Note that at this point the
following occurs:
Insert your datAshur Personal into USB port
Note:
Possible Actions
Can set either User or Admin PIN
Cannot access drive until User or Admin PIN is defined
Can change User PIN when unlocked as User
Can set Admin PIN when unlocked with User PIN
Can access data when unlocked as User
Can set User PIN when drive is locked
Can unlock drive with Admin PIN
Can change Admin PIN when unlocked as Administrator
Can perform Administrator commands
Can unlock drive with either User or Admin PIN
Can change User PIN when unlocked as User
Can change Admin PIN when unlocked as Administrator
LED ACTIVITY
A double blink indicates the drive is unlocked in Admin mode.
A single blink indicates the drive is unlocked in User mode.
www.istorage-uk.com
will double blink once and then turn solid
will double blink if correct PIN entry or
will blink alternately if PIN entry incorrect
will illuminate together for approximately
2 seconds and then:
will double blink indicating correct PIN entry
will double blink if 1
st and 2
will blink alternately if PIN entry incorrect
will illuminate in a constant state
will illuminate and flicker
nd entries match
#9