EGi Domos2 User Manual page 43

40271, 40281
m i s c e l l a d j u st m
nd
2
st st
1 1
SOFTWARE VERSION
If you need to make a technical query about the product, Technical Service may request
you to supply the equipment software version.
To find this out, do as follows:
1. Press the key at the bottom twice for one second, until AUDIO is displayed.
2. Press the key at the bottom briefly and pass AUDIO > INTERCOM > SURVEIL >
until you reach MISCELL.
3. Then press the right-hand side key ( ).
4. Press the bottom key several times until ADJUSTM is displayed.
5. Keep the key ( ) pressed until you are in the menu.
6. Navigate through the options by pressing the lower part of the control
unit, until VERS is displayed.
7. The number displayed is the software version of the equipment.
m i s c e l l a d j u st m
nd
2
st st
1 1
control unit
domotic functions
The technology incorporated into this control unit is the result of audio and domotics integration offered by
T h E R M O ST
EGi in the DOMOS2 series. If you have a central domotics control unit, you can control automated elements
from the control unit.
nd nd nd
2
2 2
NOTE:
specific type of installation.
st
1
LOCAL RAISING OF BLINDS AND AWNINGS
NOTE:
this function to be available. Consult documentation of EGi module ref. 40540.
If your DOMOS2 installation has a 40540 relay module associated to the zone where the control unit is installed
(consult the domotic module documentation), you can control the elements connected to these modules locally.
To control awnings, you will also need a 40640 module in the zone.
To control these functions, proceed as follows:
1.
2.
3.
4.
5.
GENERAL RAISING OF BLINDS AND AWNINGS
In the same manner as you control blinds and awnings locally; you can act on all the blinds and awnings
V E R S 1
in the installation.
To control these functions, proceed as follows:
nd
2
1.
2.
3.
43
Some or all the of menus described in this section may not be available, depending on your
There must be a domotic module associated to the zone in which the control is installed for
Press the key at the bottom twice for one second, until AUDIO is displayed.
Press the key at the bottom briefly and pass AUDIO > INTERCOM > SURVEIL > until you reach MISCELL.
Then press the right-hand side key ( ).
Press the lower part of the control unit repeatedly until BLIND or AWNING is displayed.
Press the left (–) and right-hand ( ) sides to lower or raise the blind or awning in the control unit area.
Press the key at the bottom twice for one second, until AUDIO is displayed.
Press the key at the bottom briefly and pass AUDIO > INTERCOM > SURVEIL > until you reach MISCELL.
Then press the right-hand side key ( ).
www.egiaudio.com