EGi Domos2 User Manual page 33

40271, 40281
RESETTING ZONE ASSIGNMENT IN THE SYSTEM
If you wish to carry out the SETUP again, you will have to reset the installation
(from the control unit), to do this, follow the procedure from the control unit
that is connected:
1. Press the key at the bottom twice for one second, until AUDIO is displayed.
2. Press the key at the bottom briefly and pass AUDIO > INTERCOM >
SURVEIL. > until you reach MISCELL.
3. Press the key on the right-hand side of the display ( ).
4. Press the bottom of the screen repeatedly until you reach ADJUSTM and
keep ( ) pressed for a few seconds.
You will be in the ADJUSTMENT menu.
5. Use the lower button to navigate to SETUP.
Press the ( ) button for a few seconds and navigate with the right and
left-hand side of the control unit until you see RESET on the screen
(between zone 50 and 1).
Then press ( ) again for a longer period of time and you will observe
after approx. 3 seconds that the word RESET no longer flashes and
changes to SETUP 1 in all the control units in the installation.
6. You have reset the installation and you will now have to assign a zone
number to each control unit, to do this follow the
procedure.
NOTE: You can revert to the main menu at any time by pressing the upper part
of the display twice.
control unit
m i s c e l l
audio functions
From your control unit, you can have complete control of the audio programmes in your installation. Below
is a description of the basic operations your control unit offers:
VOLUME CONTROL
To modify the local volume of the installation, press the sides of the control unit. The right-hand side ( )
increases the volume and the left (–) reduces the volume.
CHANGING PROGRAMMES
According to your system's Central unit and the type of control unit you have, you can choose from 1 to 3
audio programmes and one local FM programme (only control unit 40281).
Each time you press the bottom key, you will change the programme (1, 2 or 3 depending on your installation).
"Assigning zones"
Once you have gone through the programmes, change the memory of the local tuner (from 1 to 9) (40281).
AUD will be displayed if the input to the central unit is an external audio source.
You can revert to the main menu at any time by pressing the upper part of the display several times.
33
a d j u st m
nd nd
2 2
st st
1 1
S E T U P r e s e t
– – – –
nd st
1
2
st
1
www.egiaudio.com
nd
2
st
1