Table of Contents
Advertisement
Menu Settings
You can obtain information and perform various settings
using menus on the display.
Menu operations are permitted while the display shows the
menu indications, and the settings are maintained even if
you turn the unit off.
Menu Items
Wireless Menu
Menu
Submenu
Freq
—
Freq
—
Stream
—
Descramble Descramble AAA–ZZZ, 0–9 (AAA)
Freq (upper): To specify the receiving frequency by the
channel.
Freq (lower): To set the center receiving frequency.
It can be selected in 1-MHz steps.
Set it according to the transmitting frequency of the
WLL-CA50 or WLL-CA55 used in combination.
Stream: To set the operating mode of the stream selector.
Set it to Auto to automatically select an input of the
best condition for output. When you want to select a
certain input regardless of the condition, select Int-1
(internal 1), Int2 (internal 2), Ext1 (external stream
input 1), or Ext2 (external stream input 2).
Descramble: To set the 3-character descramble code
The left two character can be capital letters, the right
one character can be a capital letter or a number (0 to
9).
Note
Set the same value for the descramble code as the scramble
code of the WLL-CA50 or WLL-CA55 wireless camera
transmitter to be used in combination. If the codes do not
match, no video/audio will be output even if the reception
condition is normal.
18
Menu Settings
Values (default)
CH1–CH7 (CH4)
2406–2478 MHz (2442 MHz)
Auto, Int1, Int2, Ext1, Ext2 (Auto)
Audio Menu
Item
Submenu
Mic Gain
Mic1
Mic2
Incom
PGM MIX
Front
Level
PGM MIX ON, OFF (OFF)
Output
—
Delay
—
Embedded
—
Mic Gain: To specify the gain values of the microphones
of the camera.
Incom: To change the intercom settings.
PGM MIX: ON/OFF setting of program mixing for
the intercom signal to be sent to the camera
Front: Line selection for the INTERCOM connector
on the front panel
Level: Level setting for the INTERCOM connector
on the front panel
PGM MIX: ON/OFF setting of program mixing for
the intercom signal from the INTERCOM
connector on the front panel
Output: To set the reference value for the audio output
level.
Delay: To specify the delay of audio signal.
Embedded: To turn on and off the SDI embedded audio
output.
Setup menu
Item
Submenu
Video
—
Default Set
—
Phase
H
Coarse
Fine
SC
Output
1
2
3
Freeze Mode —
WF SEQ
—
CCU No
—
Low Batt
—
Bars
—
SDI EDH
—
Values (default)
20 to 60 dB
20 to 60 dB
ON, OFF (OFF)
ENG, PROD, Private (PROD)
00 to 99 (65)
–20 dB, 0 dB (0 dB)
0 to 40 mS (0)
OFF, ON (OFF)
Values (default)
NTSC-J, NTSC-UC,
PAL (Factory setting:
PAL)
No, Yes (No)
–99 to +99 (0)
0–360° (0)
SDI, ASI (SDI)
SDI, ASI (SDI)
SDI, ASI (SDI)
OFF, ON (OFF)
3, 4 (4)
01–99, A-Z (–)
10–11.5 V (11.0 V)
CB1, CB2
OFF, ON (OFF)
Advertisement
Table of Contents
