Sony WLL-RX55 Operation Manual page 25

Pages 9 and 10: Self-diagnosis of the RX
board
* RX Diag 1 *
Tuner-1
IF DC : OK
PLL : OK
IF Level: Over
Output : OK
Tuner-2
IF DC : OK
PLL : OK
IF Level: OK
Output : OK
Tuner-1: IF-1 statuses
IF DC: Condition of the antenna input (OK/Open/
Short)
PLL: Condition of PLL (OK/NG)
IF Level: Condition of the input level (OK/Over/Low)
Output: Condition of the tuner output (OK/NG)
Tuner-2: IF-2 statuses
IF DC: Condition of the antenna input (OK/Open/
Short)
PLL: Condition of PLL (OK/NG)
IF Level: Condition of the input level (OK/Over/Low)
Output: Condition of the tuner output (OK/NG)
* RX Diag 2 *
EXT-1 : OK
EXT-2 : None
Stream Sel:Int-1(Auto)
OFDM IC1 : OK
OFDM IC2 : NG
PLD V1.00 Config Done
EXT-1: Condition of external stream 1 (OK/Error/None)
EXT-2: Condition of external stream 2 (OK/Error/None)
Stream Sel: Operating mode of the stream selector
OFDM IC1: Condition of decoding circuit 1 (OK/NG)
OFDM IC2: Condition of decoding circuit 2 (OK/NG)
PLD: PLD version
Config: Condition of the initialization (Error/Done)
Page 11: Self-diagnosis of the DEC board
* DEC Diag *
DEC IC : OK
Reference : None
Freeze Mode : Freeze
PLD V1.00 Config Done
DEC IC: Condition of the IC (OK/RESET)
Reference: Existence of the reference signal (Exist/None)
Freeze Mode: Picture display mode at momentary signal
interruption (Freeze/Refresh)
PLD: PLD version
Config: Condition of the initialization (Error/Done)
Page 12: Self-diagnosis of the VA board
* VA Diag *
Input Video: OK NTSC-UC
Encoder : OK
R G B SEQ ENC
PIX :
WF :
SEQ : 3
PLD V1.00 Config Done
Input Video: Condition and video system (NTSC-J/
NTSC-UC/PAL) of the input signal
Encoder: Condition of the encoder
PIX: Operating mode of the picture monitor
WF: Operating mode of the waveform monitor
SEQ: Type of Sequence mode
PLD: PLD version
Config: Condition of the initialization (Error/Done)
Page 13: Self-diagnosis of the AU board
* AU Diag *
IIC Bus
Incom Select : OK
Incom(A/D D/A) : OK
F-Incom(Gain) : OK
Audio(D/A) : OK
Audio(Cont) : OK
Mic Gain Select: OK
Tally Interface: OK
Incom Select: Condition of the intercom level selection
Incom (A/D D/A): Condition of the intercom
F-Incom (Gain): Condition of the front intercom
Character Displays on the Picture Monitor
25