Table of Contents
Advertisement
Operating the Home Theater Standard 7.1,
Play in the Main Zone
and Record
in Zone 2
SIMULCAST
74
continued
1. Press the power pre key (58), then select the input device that
you want to play through the main zone. The main zone LED illu-
minates. Begin playing the device.
2. To record at the same time, press the Z2 key (60), then select the
source that you want to record by pressing the input device
selection key. After the zone 2 device LED illuminates, press the
input device selection key again. The front panel display reads:
TAPE OUT CHANGED TO ZONE 2
Start playing the source that you wish to record. Recording
begins when you start playing the source.
3. To monitor the output being recorded, switch back to the main
zone, then press the input device selection key for the device
being recorded. The material being recorded plays through the
main zone.
4. Press the input selected for main zone playback to return the
main zone to playing its original material. The recording will con-
tinue uninterrupted through zone 2.
When you are listening to or viewing a number of sources with
devices that have different trigger settings (configured through the
setup menus), you can retain a trigger setting using the previous (80)
key.
For example, you have configured your Home Theater Standard 7.1
to turn on your TV monitor when trigger 4 is on and your CD player is
set for
. You want to watch TV and listen to a CD at the
TRIGGER 4 OFF
same time. If you press the TV button or key followed by the CD but-
ton or key, the TV monitor will turn off.
To keep the monitor on and turn on the CD player, follow these
steps:
1. Press the TV button (9) or key (64) to select the device. Begin
playing the source.
2. Press the prev key (80).
3. Press the CD button (10) or key (65). Begin playing the source.
Krell Home Theater Standard 7.1
Hide quick links:
Advertisement
Table of Contents
