Front Panel Description - Krell Industries Home Theater Standard 7.1 Instructions For Use Manual

Front Panel Description

See Figure 1 on page 7
FEATURES
Basic Operation
Buttons
Note
Device Selection
Buttons and LEDs
8
The Home Theater Standard 7.1 front panel provides power on and
off; input, zone, and processing mode selection; monitoring and dis-
play of processor status; and balance and volume control. The front
panel features are described below:
1 Power Button
The power button switches the Home Theater Standard 7.1 from the
stand-by to the operational mode.
When you power off while zone 2 is selected, only zone 2 turns off. Press
the power button or HTS key a second time to power off the main zone.
2 Power LED
The blue power LED illuminates when the Home Theater Standard
7.1 is in the operational mode.
3 Stand-by LED
The red stand-by LED illuminates when the back panel power switch
(55) is on, indicating that the Home Theater Standard 7.1 is in the
stand-by mode. Krell recommends that the back panel power switch
remain on at all times.
4 Infrared Sensor
The infrared sensor receives commands from the Home Theater
Standard 7.1 remote control. For proper remote control operation,
make sure the infrared sensor is not covered or obstructed.
The Home Theater Standard 7.1 is equipped with ten source selec-
tion buttons. If properly configured, the Home Theater Standard 7.1
automatically engages the correct video and audio inputs when you
press the source selection button.
Above each button are two LEDs, one red and one green. The red
LED illuminates when the input is engaged and playing in the main
zone. The green LED illuminates when the input is engaged and
playing in zone 2.
5 DVD Button and LED
Use this button to select the digital videodisc device.
6 LD Button and LED
Use this button to select the laser disc device.
7 SAT Button and LED
Use this button to select the satellite feed device.
Krell Home Theater Standard 7.1