Krell Industries Home Theater Standard 7.1 Instructions For Use Manual page 20

Back Panel Description,
Video Inputs and Outputs,
continued
Note
Back Panel Remote
Control Connections
Note
Note
Power Connections
16
continued
51 Component Video Inputs
The Home Theater Standard 7.1 is equipped with two sets of compo-
nent video inputs.
On-screen display (OSD) is not available for progressive component video.
OSD is available for interlaced component video.
52 Comm Port RS-232 Connector
The Home Theater Standard 7.1 is equipped with an RS-232 com-
munication port, which allows you to send operational instructions
directly to the Home Theater Standard 7.1 using an external comput-
er control system. For more information, see RS-232 Port: Sending
Commands and Interpreting Data, the developer's reference for
the Home Theater Standard 7.1.
The Home Theater Standard 7.1 has a PHAST Link option.
53 RC-5 In
The RC-5 input makes custom installation easy and secure by
accepting baseband RC-5 input commands from hardwired remote
controllers.
54 12 VDC In and Out
The 12 VDC output sends a 12 Volt power on/off signal to other Krell
components via a 12 V trigger cable, as well as to other devices that
incorporate 12 Volt power on/off trigger input. The Home Theater
Standard 7.1 has four programmable 12 Volt outputs: Out1, Out2,
Out3, and Out4; and one input.
When the Home Theater Standard 7.1 is in the operational mode and a trig-
ger is configured, the 12 VDC Out provides 12 V of DC output. When the
Home Theater Standard 7.1 is in the stand-by mode or off, or if a trigger is
not configured, the DC output is 0 V.
55 Back Panel Power Switch
Use this switch to change the Home Theater Standard 7.1 from off to
stand-by.
56 IEC Connector
The Home Theater Standard 7.1 is equipped with a standard female
IEC power connector, for use with the AC power cord.
Krell Home Theater Standard 7.1