Krell Industries Home Theater Standard 7.1 Instructions For Use Manual page 33

Connecting the Home Theater Standard 7.1
to Your System,
continued
Step 6: Activating the On
Screen Display (OSD),
continued
Troubleshooting
the OSD
Video Source
Connection Scenarios
Krell Home Theater Standard 7.1
Follow these troubleshooting steps, if the OSD is not visible after you
follow the above activation steps 1 through 5:
1. Check the AC connections and the video source and monitor con-
nections to the Home Theater Standard 7.1
2. Match the video format and signal. (For example, component to
component and NTSC to NTSC.)
3. Switch the monitor from Progressive to Interlaced.
4. Make sure the selected device (device LED illuminated) has a fac-
tory default signal that matches the connection from the Home
Theater Standard 7.1 to the video monitor.
5. Press the enter key (84) on the remote control, to verify the video
signal for a device and to view the current video configuration on
the front panel display.
EXAMPLE 1: You want to use a component signal with a DVD
device and you reside in North America.
Connect the DVD device to the Home Theater Standard 7.1 and con-
nect the Home Theater Standard 7.1 to the NTSC Interlaced video
monitor using component connections. Since Figure 4 shows that the
factory default for the DVD is component, you do not need to change
the signal in the configuration menu.
EXAMPLE 2: You want to use a component connection with a
satellite source, and you reside in North America.
Connect the satellite device to the Home Theater Standard 7.1 and
connect the Home Theater Standard 7.1 to the NTSC Interlaced
video monitor using component connections. Since Figure 4 shows
that the factory default for the satellite device is s-video, you need to
change the s-video signal to component in the configuration menu.
The DVD device factory default signal is component. To change the
satellite device signal to component, first activate the DVD device by
pressing the DVD button (5) on the front panel or the DVD key (61)
on the remote control. The DVD device LED illuminates. Access
the configuration menu of the Home Theater Standard 7.1 via the
remote control menu key (82) and navigate to the
menu screen. Select
screen. Select the satellite device and change the satellite signal
from s-video to component.
and go to the
CONFIGURE VIDEO
CONFIGURE DEVICES
ASSIGN VIDEO INPUT
29