Connecting And Configuring Network Management Port 'Ctrl 0' - Dialogic IMG 1010 Quick Start Manual

Connecting and Configuring Network Management Port 'CTRL 0'

The information below will provide the user with a basic setup sequence for connecting and
configuring the IMG 1010 along with the GCEMS server to download system software and
start configuring the IMG 1010 using the ClientView GUI. On the rear of the IMG 1010 are
the network interfaces. The first interface -CTRL 0- is a Fast Ethernet port dedicated to
network management. This port is connected to the GCEMS server and allows the GCEMS
server to access the IMG 1010.
1. Connect up the cables as shown in the first figure below.
2. Once the cables are connected, configure FTP and DHCP on the GCEMS server. Locate the
MAC address that is printed on a label located on the underside rear of the IMG 1010. This
will be used in the dhcpd.conf file creation.
For more information on how to set up the services refer to the topics under the following
sections in the Online Documentation
IMG 1010-Installation and Setup Guide > IMG 1010-Software Installation and Setup

If your setup requires using an SD card to load system software refer to the topics under the
IMG 1010-SD Card heading below in Online Documentation.
IMG 1010-Installation and Setup Guide > IMG 1010-SD Card

Dialogic Corporation
IMG 1010 Quick Start Guide
Part # 07-8728-03 Page 7 of 9