To Configure Snmp Agent; Internet Time - Tenda AC1200 User Manual

To configure SNMP Agent:


Enable SNMP agent.

Configure the read operation command between SNMP management and SNMP agent. Read Community-SNMP
agent allows SNMP management to read variable in MIB with read community.

Configure the read and write operation command between SNMP management and SNMP agent. Write
Community-SNMP agent allows SNMP management to read and write variable in MIB with write community.

Configure the device name, network location and admin contact to make the device be conveniently managed by
SNMP management.

Configure the IP address to which the SNMP agent sends a trap message.

Click Apply/Save.

After above configurations, click Management > Access Control > Accessctrl to enter the access control-service
interface to enable SNMP service.

5.4 Internet Time

This page is used to set the router's system time. If Automatically synchronize with Internet time servers is checked,
the system will automatically connect to NTP server to synchronize the time.
Wireless AC1200 ADSL2+ Dual Band Modem Router
153