Front Panel Connector (Frontpnl) - Kontron KTGM45/mITX User Manual

KTD-N0793-L
3.17

Front Panel Connector (FRONTPNL)

Pull Ioh/
Note
U/D Iol
- -
- -
- -
- -
Signal Description
5V supply for external devices. SB5V is supplied during powerdown to allow wakeup
USB10/11_5V
on USB device activity. Protected by resettable 1.1A fuse covering both USB ports.
USB1+
Universal Serial Bus Port 1 Differentials: Bus Data/Address/Command Bus.
USB1-
USB3+
Universal Serial Bus Port 3 Differentials: Bus Data/Address/Command Bus.
USB3-
Maximum load is 1A or 2A per pin if using IDC connector flat cable or crimp terminals
+5V
respectively.
Hard Disk Activity LED (active low signal). Output is via 475Ω to OC.
HD_LED
Suspend Mode LED (active high signal). Output is via 475Ω.
SUS_LED
PWRBTN_IN# Power Button In. Toggle this signal low to start the ATX / BTX PSU and boot the board.
Reset Input. When pulled low for a minimum 16ms, the reset process will be initiated.
RSTIN#
The reset process continues even though the Reset Input is kept low.
LINE2-IN Line in 2 signals
MIC2 MIC2-L and MIC2-R is second stereo microphone input.
SB3V3 Standby 3.3V voltage
AGND Analogue Ground for Audio
Note 1: In order to meet the requirements of USB standard, the 5V input supply must be at least 5.00V.
Page 53
Type Signal
USB10/11_5V 1
USB1- 3
USB1+ 5
PWR GND 7
- NC 9 10
PWR +5V 11 12
OC HD_LED 13 14
PWR GND 15 16
RSTIN# 17 18
SB3V3 19 20
AGND 21 22
MIC2-L 23 24
PIN Signal Type
2 USB10/11_5V
4 USB3-
6 USB3+
8 GND PWR
LINE2-IN-L
+5V PWR
SUS_LED
PWRBTN_IN#
GND PWR
LINE2-IN-R
AGND
MIC2-R
KTGM45 Users Guide
Connector
Ioh/ Pull
Note
Iol U/D
- -
- - -
- -
- -
- - -