Connecting The Camera To A Computer - Konica Minolta DiMAGE Z20 Instruction Manual

DiMAGE_Z20_English_B412.qxd

CONNECTING THE CAMERA TO A COMPUTER

Confirm the battery has sufficient power before connecting the camera to a computer; the
full-battery indicator should be displayed on the monitor. The use of the AC adapter (sold
separately) is recommended over the use of the battery. For users with Windows 98 or
98 Second Edition, read the section on page 99 on how to install the necessary USB
driver before connecting the camera to a computer.
3
4
Initializing USB connection.
98
D -
ATA TRANSFER MODE
04.12.27 16:57 Page 98
1.Start up the computer. The computer must be on before
connecting the camera.
2.To transfer images from a memory card, insert the memory
card into the camera. To transfer images from the camera's
internal memory, remove the memory card from the
camera. To insert or remove the memory card while the
camera is connected to a computer, see page 106.
3.Open the USB port/Video-out terminal cover. Attach the
smaller plug of the USB cable to the camera. The arrow
mark on the plug should face the back of the camera. Make
sure the plug is firmly attached.
4.Attach the other end of the USB cable to the computer's
USB port. Make sure the plug is firmly attached. The
camera should be connected directly to the computer's
USB port. Attaching the camera to a USB hub may prevent
proper operation.
5.Press the main switch to turn on the camera. The USB
connection is made automatically; a screen appears to
indicate the operation. The monitor turns off when the
connection has been made. If the USB connection is not
made, disconnect the camera and restart the computer.
Repeat the connection procedure above.