Connecting The Camera To A Computer - Konica Minolta DiMAGE X21 Instruction Manual

CONNECTING THE CAMERA TO A COMPUTER

Confirm the battery has the sufficient power before connecting the camera to a computer. The use
of the AC adapter (sold separately) is recommended over the use of the battery. For users with
Windows 98 or 98SE, read the section on page 90 on how to install the necessary USB driver
before connecting the camera to a computer.
1. Start up the computer. The computer must be turned on before
connecting the camera.
2. Insert the memory card into the camera. To change the memory
card while the camera is connected to a computer, see page 98.
3. Slide the USB-port cover open. Insert the small plug of the USB
cable into the camera. Make sure the plug is firmly attached.
4. Attach the other end of the USB cable to the computer's USB
port. Make sure the plug is firmly attached. The camera should
be connected directly to the computer's USB port.
Attaching the camera to a USB hub may prevent the
camera from operating properly.
5. Turn on the camera to initiate the USB connection.
While the camera is connected to a computer, the data-
transfer screen will be displayed.
88 D -
ATA TRANSFER MODE