Konica Minolta DIMAGE Z1 Instruction Manual

Konica Minolta is a trademark or registered trademark of Konica Minolta Holdings,
Inc. DiMAGE is a trademark or registered trademark of Konica Minolta Camera, Inc.
USB DIRECT-PRINT is a trademark of Seiko Epson Corporation. PictBridge and the
PictBridge logo are trademarks of the Camera & Imaging Products Association
(CIPA). All other brand and product names are trademarks or registered trademarks
of their respective owners.
© 2003 Konica Minolta Camera, Inc. under the Berne
Convention and the Universal Copyright Convention.
Printed in Germany
1AG6P1P1853--
9222-2724-23 SY-A309/ME-030826
A
MENDMENTS
H
OW TO USE
E INSTRUCTION MANUAL
Before you begin
Please take the time to read through this instruction manual so you can enjoy all the
features of your new camera. This instruction manual does not provide instruction in
printer operation. Refer to the manual that was supplied with the printer. This manual
assumes you understand the basic operation of the camera described the camera's
instruction manual.
Activating PictBridge
Video output NTSC
1
2
Setup menu amendments
Video output NTSC
Transfer mode Data storage
PictBridge - to print images with a
PictBridge compatible printer.
USB DIRECT-PRINT and dpof print notes
To use USB DIRECT-PRINT, the transfer-mode option in section 4 of the setup menu
must be set to data storage. To make prints, read the instructions on pages 102 - 104
of the camera manual.
DPOF file created with the camera can be printed directly from the camera. See page
105 in the camera manual. However, the DPOF-print option on the menu is switched
from section 2 to section 3.
Print file?
Number of prints: 7
No
Yes
No. of prints: 7
Print size: Printer setup
Layout: Printer setup
Print quality: Printer setup
Data print: Printer setup
:start
PictBridge
If PictBridge is not active in the camera, sec-
tion 4 of the setup menu will display only one
menu option: video output.
With the section 4 tab highlighted, press the
hold the central button of the controller (1),
and then press and hold the information (i+)
button (2) until the transfer-mode option
appears.
When PictBridge is active, the transfer-mode
option is displayed in section 4 of the setup
menu. This amends page 85 in the DiMAGE
Z1 instruction manual. Two transfer modes are
available:
Data storage - to transfer data between the
camera and computer. This option must be
selected when moving image files to the com-
puter, using the camera with the DiMAGE
Viewer software, or printing with USB DIRECT
PRINT.
When using USB DIRECT-PRINT or DPOF
print, the print-file message described in the
camera manual has been replaced with the
print-setup confirmation screen. Press the
central button of the controller to begin print-
ing, or press the menu button to return to the
main screen.
Print-setup confirmation screen