Connecting The Camera To A Computer - Konica Minolta DImage X60 Instruction Manual

CONNECTING THE CAMERA TO A COMPUTER

A fully charged battery should be used when the camera is connected to a computer. The
use of the AC adapter (sold separately) is recommended over the use of the battery.
Before connecting the camera, confirm data storage is selected in the transfer-mode
option in section 3 of the setup menu (p.72). For users with Windows 98 or 98SE, read
the section on page 82 on how to install the necessary USB driver before connecting the
camera to a computer.
1.Start up the computer. The computer must be turned on before connecting the camera.
2.To transfer images from a memory card, insert the memory card into the camera. To
transfer images from the camera's internal memory, remove the memory card from the
camera. To insert or remove the memory card while the camera is connected to a
computer, see page 90.
Initializing
USB connection.
3.Slide the USB-port cover open. Insert the
small plug of the USB cable into the
camera. Insert the plug in straight, never
at an angle. Make sure the plug is firmly
attached.
3
4.Attach the other end of the USB cable to
the computer's USB port. Make sure the
plug is firmly attached. The camera
should be connected directly to the
computer's USB port. Attaching the
camera to a USB hub may prevent the
camera from operating properly.
5.Turn on the camera to initiate the USB
connection.
connected to a computer, the data-
transfer screen is displayed.
While the camera is
81