Table of Contents
Advertisement
Power Outages (No AC Power)
Your system will display System Trouble on
your touchpad LCD. You can press
silence trouble sounds (enter access code also if
prompted). When you press the
LCD will display the message No AC Power.
Your system will remain operational on the backup
battery until the power is restored or you reset the
circuit breaker. If you have further problems,
contact your installer.
Accidental Activation
Enter your code to deactivate the alarms. If the LCD
displays the interactive menu, you may also need to
press
to reset the system. If your system is
0
programmed to automatically report alarms to the
central station, you should notify them of the false
alarm. See page 33 for complete information about
what happens when an alarm occurs.
Technical Manuals Online! - http://www.tech-man.com
to
MUTE
button, the
STAT
Touchpad Display Reads "System
Trouble"
Problems with arming can occur if your system has a
trouble condition or system failure. Press
silence trouble sounds and enter your access code if
prompted. In a multi-area system, only the areas that
are accessible with your code at the touchpad you
are operating are silenced. Press
problem that your system is encountering. Contact
your installation company immediately for service.
Your system will not be fully operational until the
problem has been corrected.
Not Ready Zones
Not Ready zones occur when a door or window has
been left open or some other problem exists and is
preventing you from arming the system. Press
to identify the Not Ready zone and correct it if you
can. If you cannot correct the problem, but you must
arm the system, you can bypass the zone (see page
15 or 23).
36
to
MUTE
to see the
STAT
STAT
Advertisement
Table of Contents
