Dacor Epicure ER30G Installation Instructions Manual
30-inch gas range
Hide thumbs
Also See for Epicure ER30G:
- Installation instructions manual (21 pages) ,
- Planning manual (3 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dacor Epicure ER30G
Summary of Contents for Dacor Epicure ER30G
-
Page 1: Installation Instructions
Installation Instructions Epicure 30 - Inch Gas Range ® For use with models ER30G and ER30GI THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. Part No. 106174 Rev. G... -
Page 2: Table Of Contents
**** Use only the factory installed (1 3/4”) backguard with self-rimming installations. * See page 3 for more information. ** 4000 Ft. = 1219 M All specifications subject to change without notice. Dacor assumes no liability for changes to specifications. © 2008 Dacor, all rights reserved. -
Page 3: Important Safety Instructions
Use common sense and caution when installing, maintaining or operating this appliance. WARNING Always contact the Dacor Customer Service Team about WARNING – Failure to install this appliance as specified problems or conditions you do not understand. -
Page 4: Important Information About Safety Instructions
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. •... -
Page 5: Installation Specifications
Full stainless compatible with self-rimming installations steel side panels ER30G is designed for freestanding install- ations. ER30GI is designed for installation in a recessed cabinet or island. ER30G is Product width: NOT equipped for self-rimming installation. 29 7/8” (759mm) Overall Dimensions... -
Page 6: Electrical Power Supply Requirements
Installation Specifications Gas Supply Requirements WARNING • Be certain that the range being installed is correct for • Observe all governing codes and ordinances during the gas service being provided (natural gas or LP gas). planning and installation. Contact your local building department for further information. -
Page 7: Cabinet Layout
• To reduce the risk of personal injury and to reduce accumulated smoke in the room, Dacor strongly recommends installing a range hood. A range hood 29 1/4” (743mm) countertop opening 24”... -
Page 8: Gas And Electrical Locations
Installation Specifications Gas and Electrical Locations • The installation must allow for the following: ◊ Access to the gas shut-off valve when the unit is installed. ◊ Access to the electrical outlet, when the range is in place. ◊ The gas supply piping, gas shut-off valve and the electrical junction box or receptacle must be located so they do not interfere with the range when it is installed. -
Page 9: Backguard Kit Installation
Installation Instructions Backguard Kit Installation Slide the provided left and right trim pieces onto the range. The overhang on each piece goes toward the See the inside cover for available part numbers and back. compatibility. Fasten the new trim pieces in place using the provided If installing a backguard other than the standard size, #8 x 1/4 Torx screws (2 each side). -
Page 10: Adjust The Range Height
Installation Instructions Self-Rimming Trim Installation (cont.) Using two (2) of the provided #8 x 1/4 screws, attach the bracket to the backguard as shown. Each screw Remove and retain the two (2) hex head screws from threads into the backguard through the hole in the back the top back corners of the sides of the chassis as of the bracket. -
Page 11: Install The Anti-Tip Bracket
Installation Instructions Install the Anti-Tip Bracket Door Removal Locate the anti-tip foot on the back of the range and Remove the door to make the range easier to move during turn it until the bottom of it is 1/16” (2 mm) off the floor. the installation process. -
Page 12: Gas Connection
Installation Instructions Gas Connection IMPORTANT: The installed gas pressure regulator is pre- WARNING set at the factory for the type of gas intended for use with • Make sure the gas is turned off at the gas supply the appliance. Verify that the appliance is compatible with valve before connecting the gas line. -
Page 13: Moving The Range To Final Location
Installation Instructions Moving the Range to Final Location Carefully slide the range into position taking the slack out of the power cord as you push the unit into place. Peel the protective plastic coating off of the range, Be careful not to kink the power cord or gas line as you including the range door. -
Page 14: Cooktop Assembly
Installation Instructions Cooktop Assembly WARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. Remove the burner rings, burner caps and grates from their shipping cartons. Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. -
Page 15: Verifying Proper Operation
Repeat the above tests. Turn on the gas supply at the shut-off valve. If the appliance still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to Connect the power cord to the electrical outlet. repair the appliance yourself. Dacor is not responsible... -
Page 16: Wiring Diagram
Wiring Diagram BAKE/BROIL KNOB LED OVEN CELL ON LED Return +5VDC Wiper 120VAC from Burner Switches... -
Page 17: Notes
Notes... - Page 18 Notes...
- Page 20 Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com...
Need help?
Do you have a question about the Epicure ER30G and is the answer not in the manual?
Questions and answers