Table of Contents
Advertisement
APPENDIX J
Instructions for uploading the SP3 software.
1. You must have the SP3 connected via Ethernet cable to your local area network
and powered up, or connected directly to your laptop or PC with a network cable.
Make sure that a green light at the SP3 network socket (back panel) is lit. If not then
use a cross-over cable or verify that the network interface to which SP3 is connected,
is enabled.
2. Open a Browser on your computer (Explorer/Chrome/Safari etc)
3. Type:
or
where xx.xx.xx.xx is the actual IP address of the SP3
4. Optional - if the sp3-serialnumber method does not work then use the actual IP
address as above, for example:
http://169.254.1.1
The serial number of the SP3 as well as the actually used IP address (for example
169.254.1.1 ) are available to view by pushing the left hand navigation button on the
SP3 front panel, when the front panel shows the main (opening) screen:
(Note: the serial number is also written on the name plate at the back of the unit)
http://sp3-serialnumber/upload
http://xx.xx.xx.xx/upload
SP3 display showing the main screen
after pressing arrow key
SP3 display showing serial#, firmware rev# and ActIP
IP address shown in Miscellaneous sub menu
("ActIP" stands for "Actual IP address")
SP3 Software Upload Instructions
FIRMWARE UPLOAD INSTRUCTIONS
4-Jan-2013
Page 1 of 6
Advertisement
Chapters
Table of Contents
