Bryston SP3 Manual page 54

APPENDIX J: FIRMWARE UPLOAD INSTRUCTIONS continued
7. After selecting the SP3.bin file, click on the "Upload" button in the "File Package
Upload" window:
Note: If the internet connectivity is not available, then a "file not
found" or other error will be shown and the process will be terminated.
In such a case a local SP3.bin file must be selected. The file can be
obtained by post or email from Bryston technical support and copied into
a local directory.
The file upload starts after a few seconds (The file is read from a remote server and
that requires internet connectivity!)
Some browsers
Standby LED in SP3 will be blinking and the display on the SP3 will indicate
the upload count status.
2
Wait until the file gets uploaded to SP3 and until the self-programming process is
3
completed. SP3 will automatically load, self-program and re-power up after the
programming is finished.
Software update process consists consists of 3 cycles:
1
Chrome browser does indicate the file upload count in %, in the status line at the bottom of the window.
2
Tpically about one to two minutes. Ignore error messages that may appear in the browser window during
programming stage, due to time-out.
3
Uploading is marked by a live time count on the SP3 front panel screen but during the last self
programming stage the screen goes blank while the Standby LED will be flashing some red, yellow and
green patterns (or red, violet and blue). Do not power off while self-programming is taking place!
"File Package Upload" page of the SP3.
1
might not indicate the upload progress count, however, the
SP3 Software Upload Instructions Page 3 of 6