Bryston SP3 Manual page 46

APPENDIX G: SETUP USING LAN continued
would also work (however, the actual IP address value is determined by the DHCP lease event and may
vary).
2. SP3 setup for static host and static SP3.
This setup uses peer-to-peer physical connection using a cross-over
Ethernet port on the back of SP3 unit, directly to the second LAN2 card in the host PC. To set up the
SP3, press right arrow key to enter the menu system, then:
SYSTEM SETUPMISCELLANEOUS
Scroll to the third screen down:
Make sure that the setup screen looks on like above screen
left arrow key to escape back to the main screen, then press STANDBY button and then again to power
up, to reset the SP3 unit.
3. Host PC setup for static IP address.
Ideally, a second network
interface card (LAN2) would
connect only to SP3, while
the main network card
(LAN) would maintain the
normal network and internet
connectivity. An example of
the interface configuration is
showed at the right:
Configuration of the
second network card
(LAN2) for SP3
connectivity in the
static IP scheme
3
Some network card allow using standard (non-cross-over) Ethernet cables.
4
It is possible to edit and change the Ipadr or Ipmsk values but it should not normally be needed.
TCP/IP setup screen
4
. After making a new DHCP selection press
SP3 to LAN Setup Guide Pg. 2 of 4
3
Ethernet cable, connecting the