Appendix M: Idle Screen Explanations - Bryston SP3 Manual

APPENDIX M
SP3 DEFAULT SCREEN
1. Default screen, playing SPDIF input, PCM-encoded 2 channel stream, example
1
1 :
Line1: SRC: AES1 DIG
Program encoding: linear PCM 2ch
Line2: IN: PCM 44k 2/0
Surround re-creation mode: Dolby ProLogic IIx "Movie"
Line3: OUT: PL2xMovie 2/2/2.0
Line4: VOLUME: -21.0dB
1
Using SPDIF balanced digital source BAL1+DIGITAL, playing two channel audio file from BDP-1
2
The center speaker was configured as NONE and the rest were declared as LARGE. The ".0" ending
indicates that the subwoofer is not being used (in spite being declared as present), since the bass is
reproduced through the large front speakers. If all speakers including center were present, then the short
7.0 would have been displayed instead of the full 3/2/2.0 in such a case. If the front speakers were declared
as SMALL then the bass would have been reproduced through the subwoofer and 2/2/2.1 would have been
shown instead of 2/2/2.0
SP3 IDLE SCREEN EXPLANATIONS
SP3 IDLE SCREEN EXPLANATIONS
2011-11-24
Source
Input type (digital, analog, hdmi, bypass)
Program format (front/surr/back.lfe)
Listening format
2
(front/surr/back.subwoof)
Output volume control (level in dB)
SP3 PREAMP / PROCESSOR
IDLE SCREEN EXPLANATIONS
Sample rate (kHz)
Page 1 of 3