Stereo Down-Mix - Bryston SP3 Manual

F: MAIN / ZONE SELECT
The SP3 can send a different stereo audio source
signal to its ZONE outputs (Zone 2 Out) than to its main
outputs (Single Ended Outputs or Balanced Outputs).
Pressing the MAIN button allows selection of the signal
that will go to the Single Ended Outputs and Balanced
Outputs using the source select buttons (item "G") while
pressing ZONE allows the same source select buttons to
set the signals that will be sent to the Zone 2 Out outputs)
G: SOURCE (INPUT) SELECT BUTTONS
Ten buttons for selecting audio input source signals (see
"F" above). When HDMI is selected (LED above HDMI
button is ON) the first 8 source select buttons (DVD,
CBL/SAT, TUNER, CD, DVR, TAPE, BAL-1, BAL-2)
represent HDMI inputs 1 through 8 respectively. When
MAIN is selected, source signal selected will appear at
the MAIN outputs. When ZONE is selected, the source
signal selected will appear at the ZONE 2 OUT outputs
SP3 PREAMP / PROCESSOR
H: STANDBY BUTTON
Places the unit in standby mode. Status indicator LED is
normally off when unit is operating. It turns red when unit
is placed in standby mode. When uploading new soft-
ware it may blink off and on in different colours. The spe-
cifics of theses different colour states is significant only to
engineering and service personel.
Power consumption in Standby mode is <1 Watt.