APPENDIX F
WEB INTERFACE GUIDE
SP3 Web Interface Guide
2012-08-02, Stan Bleszynski, Bryston Ltd.
1. General guidelines (introduction).
SP3 can be connected to a PC (Windows, MacOS, Linux etc) using Ethernet cable through a local area network
hub or through a direct peer-to-peer (SP3-to-PC) using a cross-over network cable. Connection between SP3
and a PC can be established using either one of the 3 basic configuration schemes differing in the way the IP
addresses are leased out or assigned by an external or internal DHCP server. This is described in more details
in the following document on-line:
ftp://ftp.bryston.com/pub/firmware/sp3/doc/SP3_setup_using_LAN2.doc
Main SP3 web interface screen
2. Main screen.
Communication interface with the SP3 takes place over TCP/IP stack using HTTP (version 2 compat) protocol
over port 80. This can be handled by almost any internet browser, for example Internet Explorer, Chrome,
Safari, Firefox, Opera, and on any operating system platform. Once a connection is established, so-called "Net
SP3 Web Interface Guide
Page 1 of 7