Bryston SP3 Manual page 57

APPENDIX J: FIRMWARE UPLOAD INSTRUCTIONS continued
It is recommended to follow it, that is go to Miscellaneous menu, and scroll down to
DEFAULT EEPROM option
the action by exiting the screen, pressing left arrow. Alternatively, the user has a choice
to navigate to the configuration menus in order to write down (or memorize) the pre-
existing configuration, so that the old settings can be manually re-inserted after the re-
default.
A fresh 2012.11 upgrade may results in some EEPROM related error messages to be
displayed in the SYSTEM SETUP-->TESTS-->SYSTEM STATUS screen, which
should clear after executing DEFAULT EEPROM and re-powering (re-plugging)
unit. It is recommended not to use revision 2012.11.
Firmware revisions 2012.12 and later, have restored the automatic EEPROM redefault
following an upgrade, due to frequently encountered problems involving uninitialized or
mis-initialized parameters.
It is strongly recommended to use the latest firmware revision!
6
The hidden menu screens will be already automatically unlocked, so no need to press Zone,DVD,Tape!
7
Standby will not clear it! Alternatively, error messages can be manually cleared by pressing the right
arrow on the error screen, or cleared from the TCP/IP or RS232 terminal by issuing .c command.
6
, press Surround arrow key to select "DO IT" and execute
Stan Bleszynski
Bryston Ltd.
SP3 Software Upload Instructions
-------
Page 6 of 6
SP3 PREAMP / PROCESSOR
7
the