Removal From Storage - Honda CG150 Titan ES Owner's Manual

98
6. Wash and dry the motorcycle. Protect all painted
surfaces by applying silicon-based wax. Apply rust-
inhibiting spray to the wheel rims, forks and shock
absorbers, exhaust pipe (including inner surface)
and other chromed components.
NOTE
Apply rust-inhibiting spray only with the engine cold.
The excess can be removed after 24 hours.
7. Remove all excess of water and lubricate the control
cables.
8. Inflate the tires to the recommended pressure. Place
the motorcycle on blocks to raise both tires off the
ground.
9. Cover the motorcycle with an appropriate cover.
Do not use plastic covers or other impermeable
materials. Store it in a cool area, free of dampness
and with a minimum daily temperature variation.
Do not store the motorcycle in direct sunlight.
Use an appropriate cover.
(Illustration only for reference)

Removal from Storage

When the motorcycle is to be used again, follow the
procedures below:
1. Uncover and clean the motorcycle. Change the oil if
more than 4 months have passed since the start of
storage.
2. Slow charge the battery as required and install it.
3. Drain any excess of aerosol rust-inhibiting oil from
the fuel tank. Fill it with fresh gasoline.
4. Perform all Pre-ride Inspection checks. Test ride the
motorcycle at low speed in a safe riding area away
from traffic.
Clean the inside of the fuel tank
and fill with fresh gasoline.
Charge the
battery.
Owner's Manual
Change the
engine oil.
(Illustration only for reference)