Canon VB-M700F Operation Manual page 50

Important
• Contact your System Administrator for the [IPv4 Address],
[Subnet Mask] and [IPv4 Default Gateway Address].
• The camera's IP address cannot be set to an IP address that
starts with 127., such as 127.0.0.1.
• If any of the [IPv4 Address], [Subnet Mask] or [IPv4 Default
Gateway Address] settings is wrong, network access may be
disabled. In this case, see "Performing Initial Settings for the
Camera" (p. 2-6) and use VB Initial Setting Tool to set the
address again.
• The camera may become inaccessible from the active web
browser if settings are changed in [IPv4 Address], [Subnet
Mask] or [IPv4 Default Gateway Address]. Check beforehand
the precautions in "Important" in "[Reboot Item] Setting Items
Requiring Rebooting" (p. 5-32).
• If [Auto (DHCP)] is selected as the IPv4 address setting
mode, the IPv4 address may not be assigned correctly in
certain environments, such as when a router is present
between the DHCP server and the camera. In this case,
assign a fixed IPv4 address from the [Manual] settings.
IPv6
(1) [IPv6]
Set IPv6 use to [Disable] or [Enable].
(2) [Auto]
Select [Enabled] to set the address automatically or
[Disabled] not to set the address automatically.
(3) [IPv6 Address (Manual)]
Enter a fixed IPv6 address.
(4) [Prefix Length]
Enter a prefix length from 16 to 128 if [Disabled] is
specified in (2).
(5) [IPv6 Default Gateway Address]
Enter a default gateway address if [Disabled] is
specified in (2). Be sure to set when connecting the
camera to a different subnet from that of the viewer.
(6) [IPv6 Address (Auto)]
If [Enable] is specified in (1) and [Enabled] is
specified in (2), then the automatically acquired
address will be shown.
5
-6
Important
• Contact your System Administrator for the [IPv6 Address
(Manual)], [Prefix Length] and [IPv6 Default Gateway
Address].
• The camera may become inaccessible from the active web
browser if settings are changed in [IPv6], [IPv6 Address
(Manual)], [Prefix Length] or [IPv6 Default Gateway Address].
Check beforehand the precautions in "Important" in "[Reboot
Item] Setting Items Requiring Rebooting" (p. 5-32).
Note
In an environment where IPv6 cannot be used, if IPv6 is set to
[Enable] and auto is set to [Enabled], then the [IPv6 Address
(Auto)] field will display the link-local address only.
DNS
(1) [Name Server Address 1], [Name Server Address 2]
Enter the name server address you want to register.
To register only one address, keep the [Name Server
Address 2] field blank.
(2) [Host Name]
You can register the host name of the camera in the
name server.
Characters A to Z, a to z, 0 to 9, "-" (hyphen), "_"
(underscore) and "." (period) may be used up to 63
(single-byte) characters in length.
(3) [Host Name Registration with DDNS]
Select [Enable] to register the entered name server
address and host name of the camera.
Important
Do not use "_" (underscore) in [Host Name] in Internet Explorer 8/
9/10.
Note
• Use [Host Name Registration with DDNS] if the camera IP
Address Setting Method is [Auto (DHCP)] (p. 5-5). DNS server
registration settings must be set in advance. Contact your
System Administrator for the DNS server settings.
• If the name server address 1 is unavailable, the name server
address 2 will be accessed. However, the name server
address 2 must be set in advance.