Accessing Component In The Refrigerator Compartment - KitchenAid Job Aid 4322312 Technical Education

9. remove the two (2) clips securing the
heater to the evaporator bottom and slide
the heater down until it disengages from
the evaporator. (Fig. 21)
Accessing Components in the Refrigerator Section
Accessing the Control Box
The control box is located at the front of the refrigerator section and is secured to the refrigerator
compartment ceiling. The control box contains:
• The cold air damper control
• The defrost timer
• Freezer temperature control thermostat
• The switch for the refrigerator compartment lights
• Mullion moisture control switch
1. Remove the two (2) Phillips-head screws securing the front of the control box to the ceiling to
the refrigerator section.
2. Remove the two (2) Phillips-head screws hidden inside the standoffs at the back of the control
box.
3. Move the temperature controls toward the center of the control box to prevent the control racks
from interfering with the removal of the control box.
4. Lower the control box down. Carefully pull the freezer temperature-sensing tube from the hole
in the divider between the freezer and refrigerator compartments.
5. Unplug the six-pin wiring harness connector block and the violet and blue wire connectors.
Air
Damper
Control
The control box can now be removed from the refrigerator compartment. (Fig. 22)
Air
Damper
Mullion Heater
Switch
Fig. 21
Retaining Clip
Violet & Blue Wire Connectors
Light
Switch
Fig. 22
12
Evaporator
Retaining Clip
Defrost Heater
Wiring
Harness
Connector
Defrost
Timer
Thermostat