Diagnostic Information - KitchenAid Job Aid 4322312 Technical Education

PERFORMANCE DATE
*(NORMAL OPERATING CONDITIONS)
AMB WATTS
70° 190
90° 205
110° 210
SERVICE INFORMATION
1. Do not interchange the compressor suction and process stubs.
2. Refrigerant charge must be applied to high side only.
3. Ice maker and water valve not original equipment on all models.
4. CAUTION: Ice maker cycle MUST be initiated electrically. Do not try to manually start cycle.
5. Service defrost bi-metal (55°F) open.
6. Defrost timer may contain a capacitor in series with motor. Do not continuity test when checking
for failed timer motor. Instead, energize timer and listen for gear movement.
7. Part number can be found on component.
BE SURE AND USE CORRECT REPLACEMENT PARTS
120VAC
COMPONENT
COMPRESSOR
RUN WINDING
START WINDING
PTC RELAY
OVERLOAD
RUN CAPACITOR
THERMOSTAT
DEFROST TIMER MOTOR
DEFROST HEATER
BI-METAL
EVAPORATOR FAN
CONDENSER FAN
MULLION HEATER

DIAGNOSTIC INFORMATION

! WARNING
ELECTRIC SHOCK HAZARD
Disconnect the electrical power before servicing any components.
Failure to do so can result in death or electrical shock.
SYSTEM PRESSURE
(PSIG)
HIGH LOW
SIDE SIDE
90 1
135 2
185 2
GENERAL COMPONENT INFORMATION
WATTAGE
@120VAC
--
--
--
--
--
--
--
.7
505
--
11
10
12.1
*Normal operating conditions are viewed when
air and temperature controls are at mid-setting,
freezer section temperature is between 0°- 5°F
and unit is cycling.
NOTE: Watt and pressure readings will vary and
are influenced by existing condition of
the appliance, such as iced-up evap-
orator, condition of the condenser, de-
frost cycle, pull-down time and customer
use.
OHMS
RESISTANCE
--
2.6
4.35
--
--
--
--
13000
30
--
--
--
1650
17
TECUMSEH
TP1380Y
12049702
--
--
10097202
10377015
C8931604
RO161075
10428601
10991107
10449501
10654206
10884501
10543603