KitchenAid Job Aid 4322312 Technical Education page 21

1. Remove the doors and center hinge.
2. Remove the Phillips-head screw in the ceiling of the refrigerator compartment that secures the
center mullion cover to the cabinet.
3. Press in on one side of the mullion cover and slide it until the opposite side clears the cabinet
flange.
4. Remove the mullion cover.
5. Unplug the wire connectors from the mullion heater terminals and remove the mullion heater.
CONFIRMATION OF LEARNING CONFIRMATION OF LEARNING
CONFIRMATION OF LEARNING CONFIRMATION OF LEARNING CONFIRMATION OF LEARNING
In the blank to the left of the statement, place a T if the statement is TRUE or an F if the statement
is FALSE.
___1. The thermostat to control temperature in the freezer section is located in the refrigerator
compartment.
___ 2. The heat exchanger and main wiring harness is accessible behind a panel attached to the
back of the cabinet.
___ 3. The defrost timer is located in a box behind the toe grille at the bottom of the unit.
___ 4. The automatic damper control that regulates air flow into the refrigerator compartment
must be disconnected from the wiring harness when it is to be replaced.
___ 5. The defrost bi-metal thermostat is attached to the back wall of the freezer compartment.
If a 1998 Model "G" 25 cu. ft. Top-Mount Refrigerator/Freezer is available, perform the following
service procedures:
A. Perform all the steps necessary to pull the component compartment slide-out tray out a few
inches to access the compressor and condenser fan.
B. Perform all steps necessary to remove the defrost heater element from the evaporator.
C. Perform all steps necessary to remove the temperature control thermostat from the control
box.
D. Perform all steps necessary to remove the damper door assembly and damper control
thermostat.
Accessing The Mullion Heater
SECTION THREE
EXERCISES EXERCISES EXERCISES
EXERCISES EXERCISES
14