Rear Suspension - Arctic Cat S2009F5DFCUSG Operator's Manual

Crossfire/M-Series Models
On the Bearcat/F-Series/Z1/T-Series/
TZ1 models, turn the handlebar to the
right; then from the right side, pump
grease into the steering arms until
grease is noted coming out of either
end of the arms. Wipe excess grease
from the arms.
Bearcat/F-Series/Z1/
T-Series/TZ1 Models

REAR SUSPENSION

(Every 40 Operating
Hours)
 NOTE: Arctic Cat recommends
that Arctic Cat Low-Temp Grease
(p/n 4639-365) be used for this pro-
cedure.
38
 NOTE: Illustrated are the general
locations of grease fittings. Actual
locations will vary from model to
model.
1. Shut engine off and wait for all
moving parts to stop.
2. With the gas tank nearly empty
(less than 1/4 full), lay the snow-
mobile on its left side. A piece of
cardboard should be used to pro-
0743-219
tect the finish on the hood and
belly pan.
3. Remove ice and snow buildup
from the skid frame to expose the
grease fittings.
0741-440
4. Lubricate the grease fittings with
low-temperature grease.
0741-376
LUBRICATION