Front Suspension; Rear Suspension; Lubrication - Arctic Cat 2010 Crossfire 600 Operator's Manual

21. Install the driven pulley; then
install the drive belt (see Drive
Belt sub-section) and the belt
guard.
22. Install the left-side access panel;
then close the access panel.

FRONT SUSPENSION

 NOTE: Arctic Cat recommends
that Arctic Cat Low-Temp Grease
(p/n 4639-365) be used for this pro-
cedure.
It is very important that the front sus-
pension is greased on a monthly basis
using low-temperature grease. The
front suspension should also be greased
after trailering the snowmobile on an
open trailer. Pump grease into the spin-
dle grease fitting (both sides) until
grease is noted coming out of the top
and bottom of the spindle. Wipe excess
grease from the spindle.
Pump grease into the upper steering
shaft grease fitting (located on each
side of the snowmobile directly below
the inner cap screw securing the upper
A-arm to the chassis) until grease is
noted coming out of the bottom of the
shaft. Wipe excess grease from the
shaft.

LUBRICATION

REAR SUSPENSION

(Every 40 Operating
Hours)
 NOTE: Arctic Cat recommends
that Arctic Cat Low-Temp Grease
(p/n 4639-365) be used for this pro-
cedure.
 NOTE: Illustrated are the general
locations of grease fittings. Actual
locations will vary from model to
model.
1. Shut engine off and wait for all
moving parts to stop.
2. With the gas tank nearly empty
(less than 1/4 full), lay the snowmo-
bile on its left side. A piece of card-
board should be used to protect the
finish on the hood and belly pan.
3. Remove ice and snow buildup
from the skid frame to expose the
0737-294
grease fittings.
4. Lubricate the grease fittings with
low-temperature grease.
0743-219
0741-376
25