Speedometer/Tachometer Indicator Icons (Premium Gauge) - Arctic Cat S2009F5DFCUSG Operator's Manual

4. If the warning light does not go
out, shut the engine off immedi-
ately and repeat step 2; then repeat
step 3.
If the warning light does not go out or
if the engine does not start, take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer. If not under
warranty, this service is at the discre-
tion and expense of the snowmobile
owner.
SPEEDOMETER/
TACHOMETER
INDICATOR ICONS
(Premium Gauge)
Certain models are equipped with a
premium gauge combination speedom-
eter/tachometer. Indicator icons are
incorporated within the speedometer/
tachometer. Also incorporated into the
speedometer/tachometer is a digital
readout screen.
A. High Beam
B. Oil Pressure/Low Oil
C. Coolant Temperature
D. Increment Button
E. Select Button
F. Decrement Button
G. Service
H. Charging System (1100 cc)
GENERAL INFORMATION
RPM/MPH (kph)
By pushing the increment button once,
the RPM and MPH will be displayed
(one on the readout screen and one
with the needle). By pushing the button
once again, the functions will be
reversed.
By pushing the increment button (with
speed being displayed) for more than
two seconds, the display will change
between standard mph or metric kph.
With RPM displayed on the readout
screen by pushing and holding the
increment button, maximum RPM will
be displayed on the readout screen. The
maximum RPM readout will reset
when the decrement button is pushed
(while maximum RPM is displayed).
Odometer/Trip-Meter
(1)/Trip-Meter (2)/
Hour-Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the
trip meter displayed, push and hold the
decrement button until the display is
cleared. The hour-meter readout will
not reset.
Clock/Altimeter
FZ001A
 NOTE: The altimeter is available
on the 800/1000/1100 cc models
only.
By pushing the select button, the read-
out screen will display clock, altimeter,
and maximum altimeter.
With clock selected on the display by
pushing and holding the select button
for two seconds, the option of selecting
the 12-hour or 24-hour clock mode is
available. Push the increment button to
toggle between the 12-hour display and
the 24-hour display. When desired
mode is displayed, push the select but-
ton.
11