Rear Suspension - Arctic Cat Bearcat 570 2012 Operator's Manual

On the F5 LXR/F570 models, turn the
handlebar to the right; then from the right
side, pump grease into the steering arms
until grease is noted coming out of either
end of the arms. Wipe excess grease from
the arms.
F5 LXR/F570 Models

Rear Suspension

This procedure should be done every 40
operating hours.

NOTE: Arctic Cat recommends
that Arctic Cat All-Temp Grease (p/n
4639-365) be used for this proce-
dure.
32

NOTE: Illustrated are the general
locations of grease fittings. Actual
locations will vary from model to
model.
1. Shut engine off and wait for all mov-
ing parts to stop.
2. With the gas tank nearly empty (less
than 1/4 full) and using Handlebar
Stand (p/n 5639-152) or a suitable
substitute, lay the snowmobile on its
741-335A
left side.
3. Remove ice and snow buildup from
the skid frame to expose the grease
fittings.
0741-440
4. Lubricate the grease fittings with all-
temperature grease.
0741-376