Arctic Cat S2009F5DFCUSG Operator's Manual page 40

6. Secure the snowmobile in this
position until the lubricant is com-
pletely drained.
! CAUTION
It is critical that all of the old lubri-
cant be drained from the gear case
prior to flushing the gear case.
7. When the lubricant has completely
drained form the gear case, tip the
snowmobile back to the upright
position, remove the drain adapter,
and install and securely tighten the
drain plug; then remove the check/
fill plug.
8. Pour the recommended amount of
Arctic Cat ACT Drive Flush Fluid
(p/n 4639-333) into the check/fill
hole; then install the plug. Tighten
securely.
! CAUTION
Do Not add more or less than the
recommended amount of flush
fluid to the gear case.
9. Install the driven pulley; then
install the drive belt (see Drive
Belt sub-section) and the belt
guard.
10. Install the left-side access panel;
then close the access panel.
11. Position the tips of the skis against
a wall; then using a shielded safety
stand, raise the rear of the snow-
mobile off the floor making sure
the track is free to rotate.
! WARNING
The tips of the skis must be posi-
tioned against a wall or similar
object.
36
! WARNING
DO NOT stand behind the snowmo-
bile or near the rotating track.
NEVER run the track at high speed
when the track is suspended.
12. Start the engine and accelerate
slightly. Use only enough throttle
to turn the track several revolu-
tions. SHUT ENGINE OFF.
13. Open the left-side access panel;
then remove the panel and the belt
guard.
14. Remove the drive belt (see Drive
Belt sub-section); then remove the
driven pulley.
15. Tip the snowmobile onto its right
side and place a piece of cardboard
underneath.
16. Remove the drain plug from the
gear case; then install the drain
adapter fitting with hose into the
drain plug hole.
17. Tip the snowmobile back to the
upright position; then place a drain
pan on the floor next to the drain
hose and tip the snowmobile
toward its left side far enough to
allow the flush fluid to drain from
the gear case into the drain pan.
18. Secure the snowmobile in this
position until the flush fluid is
completely drained.
! CAUTION
It is critical that all of the flush fluid
be drained from the gear case prior
to filling with new lubricant.
LUBRICATION