Speco VIP2PTZ12X User Manual page 35

- Mail Server/Port: Enter the host names (or IP addresses) and port numbers for your
mail server in the fields provided to enable the sending of notifications and image email
messages from the network camera to predefined addresses via SMTP.
- Sender: Enter the email address to be used as the sender for all messages sent by the
network camera.
- Interval: Represents the frequency of the email notification when an event occurs.
- Aggregate events: Shows the maximum number of emails sent within each interval.
If your mail server requires authentication, check the box for use (SMTP) authentication to
log in to this server and enter the necessary information.
- User name/Password: Enter the User name and Password as provided by your
network administrator or ISP (Internet Service Provider).
To ensure that the login procedure is performed as securely as possible when using
SMTP authentication, you must define the weakest authentication method allowed.
- Login method: Set the Weakest method allowed to the highest/safest method
supported by the mail server. The most secure method is listed in the drop-down list:
* AUTH LOGIN/AUTH PLAIN
• • • • SMTP (E-Mail) Receiver:
- Receiver: Enter an email address. You can also register the e-mail address of up to 8
recipients.
• • • • SMTP (E-Mail) Test:
- Receiver: Enter an email address and click the Test button to test that the mail servers
are functioning and that the email address is valid.
FTP & JPEG
When the network camera detects an event, it can record and save images to an FTP
server. Images can be sent as e-mail attachments. Check the box to enable the service.
• • • • FTP Setting:
- Server: Enter the server's IP address or host name.
35